SPECIAL SOLUTIONS – 2″ caster for cable carrier chains GMS 211 FBB
Load capacity up to 400Kg
RIG
Reinforced without central pin, with single hardened and guarded ball raceway. Bolted wheel axle.
Wheel
BP – Thermoplastic Compound with PVC. Hardness: 80 Shore A. (-10°C to +50°C).
Produced with recyclable thermoplastic compound with PVC tread and polypropylene copolymer wheel center. They offer a soft and quiet rolling, great floor protection, good chemical, wear and impact resistance, resulting in an excellent cost-benefit ratio. Nominal working speed is up to 4km/h.
Capacity up to 900Kg
RIG
Reinforced without central pin, with single hardened and guarded ball raceway. Bolted wheel axle.
RODA
F – Cast Iron. Hardness: 160 Brinell. (-40°C to +400°C).
Produced with grey cast iron, they roll easily offering a great handling effort reduction. They are very resistant withstanding high loads and temperatures. They are not indicated to utilization when noise level and floor maintenance are required.
Load capacity up to 1000Kg
RIG
Reinforced rig, made of stamped steel plate and swivel head with double ball raceway, zinc-plated finish. Bolted wheel axle.
Wheel
C – Celeron Hardness: 103 Rockwell M. (-30°C to +120°C).
Manufactured with a compound obtained from macerated cotton fibers drenched with phenolic resin, molded by heat and pressure. They have excellent mechanical properties, are light and rugged, resistant to deformation under static loads and roll easily. They can be used over a wide temperature range. They are resistant to mild oils, greases and acids in low concentrations. Not recommended for applications in wet environments in contact with alkaline substances. (e.g., caustic soda, chlorine, cleaning products, soap and detergent). Nominal working speed is up to 4km/h.
Load capacity up to 3600Kg
RIG
DE: Reinforced rig, made of carbon steel, swivel section with axial ball bearing and taper roller bearings. Painted finishing. Bolted wheel axle. DERX: Reinforced rig, made of carbon steel, swivel section with two ball bearing and taper roller bearings . Painted finishing. Bolted wheel axle.
Wheel
BS – Double-Layered Molded Rubber. Hardness: 80 Shore A. (-20°C to +70°C).
Produced with molded double-layered vulcanized rubber tread over a grey cast iron wheel center. Ideal for external floor applications, offer a great shock and vibration absorption, high resistance to abrasion and longer service life due to their thicker rubber layer. Resistant to chemicals. They can be used at a speed of up to 20km/h when mounted with ball bearings.