SPECIAL SOLUTIONS – 8″ wheel. Tread has a thick PVC layer for warehouse carts R 82 BPE – Offset Hub
Load capacity up to 550Kg
RIG
Reinforced rig, made of stamped steel plate and swivel head with double ball raceway, zinc-plated finish. Bolted wheel axle.
Wheel
NU – Molded polyurethane with Nylon Wheel Center. Hardness: 90 Shore A. (-40°C to +80°C).
Produced with a molded polyurethane tread and injected nylon wheel center. The mechanical bond system ensures excellent resistance and service life. Ideal for applications on various surfaces and environment types. They are light, withstand high loads, protect the floor, require less effort to handle and produce low noise level during handling. They have an excellent resistance to abrasion, impacts, weathering and chemicals such as greases, oils, salts and solvents. They may be used in a speed up to 4km/h.
Load capacity up to 800Kg
RIG
Reinforced without central pin, with single hardened and guarded ball raceway. Bolted wheel axle.
Wheel
C – Celeron Hardness: 103 Rockwell M. (-30°C to +120°C).
Manufactured with a compound obtained from macerated cotton fibers drenched with phenolic resin, molded by heat and pressure. They have excellent mechanical properties, are light and rugged, resistant to deformation under static loads and roll easily. They can be used over a wide temperature range. They are resistant to mild oils, greases and acids in low concentrations. Not recommended for applications in wet environments in contact with alkaline substances. (e.g., caustic soda, chlorine, cleaning products, soap and detergent). Nominal working speed is up to 4km/h.
Load capacity up to 400Kg
RIG
Reinforced without central pin, with single hardened and guarded ball raceway. Bolted wheel axle.
Wheel
BP – Thermoplastic Compound with PVC. Hardness: 80 Shore A. (-10°C to +50°C).
Produced with recyclable thermoplastic compound with PVC tread and polypropylene copolymer wheel center. They offer a soft and quiet rolling, great floor protection, good chemical, wear and impact resistance, resulting in an excellent cost-benefit ratio. Nominal working speed is up to 4km/h.
Load capacity up to 3600Kg
RIG
DE: Reinforced rig, made of carbon steel, swivel section with axial ball bearing and taper roller bearings. Painted finishing. Bolted wheel axle. DERX: Reinforced rig, made of carbon steel, swivel section with two ball bearing and taper roller bearings . Painted finishing. Bolted wheel axle.
Wheel
BS – Double-Layered Molded Rubber. Hardness: 80 Shore A. (-20°C to +70°C).
Produced with molded double-layered vulcanized rubber tread over a grey cast iron wheel center. Ideal for external floor applications, offer a great shock and vibration absorption, high resistance to abrasion and longer service life due to their thicker rubber layer. Resistant to chemicals. They can be used at a speed of up to 20km/h when mounted with ball bearings.