Reinforced without central pin, with single hardened and guarded ball raceway. Bolted wheel axle.
TB – Thermoplastic Rubber. Hardness: 80 Shore A. (-20°C to +70°C).
Produced with recyclable thermoplastic elastic rubber tread and polypropylene copolymer wheel center. They present an excellent floor protection, soft and quiet rolling, easiness to handling and maneuvering, impact resistance, have a low deformation index under load and excellent abrasion resistance. They have a good resistance to weathering and chemicals such as salts and greases. Nominal working speed is up to 4km/h.
Reforçado sem pino central, com pista simples de esferas endurecidas e blindadas. Eixo da roda parafusado.
UP – Thermoplastic Polyurethane. Hardness: 90 Shore A. (-20°C to +70°C).
Produced with recyclable thermoplastic elastollan polyurethane tread and polypropylene copolymer wheel center. Ideal for those who look for an excellent load capacity added to great floor protection with low noise rolling, offering an excellent resistance to abrasion and impacts. Resistant to greases, mineral oils and some acids. Nominal working speed is up to 4km/h.
Reinforced rig, made of stamped steel plate and swivel head with double ball raceway, zinc-plated finish. Bolted wheel axle.
C – Celeron Hardness: 103 Rockwell M. (-30°C to +120°C).
Manufactured with a compound obtained from macerated cotton fibers drenched with phenolic resin, molded by heat and pressure. They have excellent mechanical properties, are light and rugged, resistant to deformation under static loads and roll easily. They can be used over a wide temperature range. They are resistant to mild oils, greases and acids in low concentrations. Not recommended for applications in wet environments in contact with alkaline substances. (e.g., caustic soda, chlorine, cleaning products, soap and detergent). Nominal working speed is up to 4km/h.
DE: Reinforced rig, made of carbon steel, swivel section with axial ball bearing and taper roller bearings. Painted finishing. Bolted wheel axle. DERX: Reinforced rig, made of carbon steel, swivel section with two ball bearing and taper roller bearings . Painted finishing. Bolted wheel axle.
P – Molded Polyurethane. Hardness: 90 Shore A. (-40°C to +80°C).
Produced with a molded polyurethane tread and grey cast iron wheel center. Ideal for applications on various surfaces and environment types The withstand high loads, protect the floor, require less effort to handle, produce low noise level during handling, and have an excellent service life. They have great resistance to abrasion, impacts, weathering and chemicals such as greases, oils, salts and solvents. They can be used at a speed of up to 20km/h when mounted with ball bearings.