Reinforced without central pin, with single hardened and guarded ball raceway. Bolted wheel axle.
TP – Thermoplastic Compound. Hardness: 80 Shore A. (-10°C to +50°C).
Produced with recyclable thermoplastic compound tread and polypropylene copolymer wheel center. They offer a soft and quiet rolling, excellent floor protection, good chemical, wear and impact resistance, resulting in an excellent cost-benefit ratio. Nominal working speed is up to 4km/h.
Reforçado sem pino central, com pista simples de esferas endurecidas e blindadas. Eixo da roda parafusado.
UP – Thermoplastic Polyurethane. Hardness: 90 Shore A. (-20°C to +70°C).
Produced with recyclable thermoplastic elastollan polyurethane tread and polypropylene copolymer wheel center. Ideal for those who look for an excellent load capacity added to great floor protection with low noise rolling, offering an excellent resistance to abrasion and impacts. Resistant to greases, mineral oils and some acids. Nominal working speed is up to 4km/h.
Reinforced rig, made of stamped steel plate and swivel head with double ball raceway, zinc-plated finish. Bolted wheel axle.
C – Celeron Hardness: 103 Rockwell M. (-30°C to +120°C).
Manufactured with a compound obtained from macerated cotton fibers drenched with phenolic resin, molded by heat and pressure. They have excellent mechanical properties, are light and rugged, resistant to deformation under static loads and roll easily. They can be used over a wide temperature range. They are resistant to mild oils, greases and acids in low concentrations. Not recommended for applications in wet environments in contact with alkaline substances. (e.g., caustic soda, chlorine, cleaning products, soap and detergent). Nominal working speed is up to 4km/h.
Reinforced rig with an anti-shock spring system, manufactured in thick carbon steel with stamped and machined parts, swivel section with axial ball bearing and tapered roller bearing. Painted finishing. Bolted wheel axle.
BS – Double-Layered Molded Rubber. Hardness: 80 Shore A. (-20°C to +70°C).
Produced with molded double-layered vulcanized rubber tread over a grey cast iron wheel center. Ideal for external floor applications, offer a great shock and vibration absorption, high resistance to abrasion and longer service life due to their thicker rubber layer. Resistant to chemicals. They can be used at a speed of up to 20km/h when mounted with ball bearings.